.. _skiboot-6.0.6: ============= skiboot-6.0.6 ============= skiboot 6.0.6 was released on Thursday July 19th, 2018. It replaces :ref:`skiboot-6.0.5` as the current stable release in the 6.0.x series. It is recommended that 6.0.5 be used instead of any previous 6.0.x version, especially in the case where NVLINK2 GPUs and/or Mellanox CX5 adapters are being used. Over :ref:`skiboot-6.0.5` we have several important performance related bug fixes and one stability bug fix: - phb4/CAPI: Reallocate PEC2 DMA-Read engines to improve GPU-Direct bandwidth We reallocate additional 16/8 DMA-Read engines allocated to stack0/1 on PEC2 respectively. This is needed to improve bandwidth available to the Mellanox CX5 adapter when trying to read GPU memory (GPU-Direct). If kernel cxl driver indicates a request to allocate maximum possible DMA read engines when calling enable_capi_mode() and card is attached to PEC2/stack0 slot then we assume its a Mellanox CX5 adapter. We then allocate additional 16/8 extra DMA read engines to stack0 and stack1 respectively on PEC2. This is done by populating the XPEC_PCI_PRDSTKOVR and XPEC_NEST_READ_STACK_OVERRIDE as suggested by the h/w team. - phb4: Disable nodal scoped DMA accesses when PB pump mode is enabled By default when a PCIe device issues a read request via the PHB it is first issued with nodal scope. When accessing GPU memory the NPU does not know at the time of response if the requested memory page is off node or not. Therefore every read of GPU memory by a PHB is retried with larger scope which introduces bandwidth and latency issues. On smaller boxes which have pump mode enabled nodal and group scoped reads are treated the same and both types of request are broadcast to one chip. Therefore we can avoid the retry by disabling nodal scope on the PHB for these boxes. On larger boxes nodal (single chip) and group (multiple chip) scoped reads are treated differently. Therefore we avoid disabling nodal scope on large boxes which have pump mode disabled to avoid all PHB requests being broadcast to multiple chips. - npu2/hw-procedures: Enable parity and credit overflow checks Enable these error checking features by setting the appropriate bits in our one-off initialization of each "NTL Misc Config 2" register. The exception is NDL RX parity checking, which should be disabled during the link training procedures.